For All-in-One panels, it is generally recommended to plug the battery in first. Plug the transformer and the battery back in. There will be no lights on the system, and the screen will be blank.ģ. With the battery and transformer unplugged, the system should immediately power down.
Locate the transformer, and unplug it from the wall outlet. The backup battery will usually plug-in to the system's board, and it can be easily disconnected.Ģ. Open up the system, and disconnect the backup battery. We have this FAQ for power cycling a wireless system, as well as this FAQ for power cycling a wired system.Ĭomplete the following steps to perform a power reset:ġ. One important note though is that when you are restoring power for a wireless system, you should connect the backup battery first and restore AC power second, but for a wired system, you generally want to restore AC power first and then reconnect the backup battery second. However, automatic dispatch may still occur if the system is set up with a monitoring station and the user does not have alarm verification.Īs for performing a power cycle reset, the process is relatively simple across all systems. The siren for the system should stop sounding, and the alarm event will be cleared. This can be done by simply entering in a valid system user code or the system Master Code. Meanwhile, an alarm reset is the process of clearing the system following an alarm event. Check out this FAQ for resetting a wireless system, as well as this FAQ for resetting a wired system. This process is different for each type of alarm system. A factory reset, also called factory defaulting, is a special process used to reset every system setting to its factory default settings.
There is also a factory reset and an alarm reset. However, a power reset is not the only type of system reset. Then reconnect the battery and transformer to power it back on. To power down the system, the backup battery must be disconnected, and the transformer must be unplugged.
You can reset your alarm system by powering it down and then powering it back on.
0 kommentar(er)
